Meyer Sound MICA

Enclosure : Multi-ply hardwood

Finish : Black textured

Frequency Response : 75 Hz - 17 kHz Â±4 dB

Height : 339.60 mm

Impedance : 10000 ohm

Input Impedance : 10 kohms differential between pins 2 and 3

Width : 1051.56 mm

Input Level : Audio source must be capable of producing a minimum of +20 dBV (10 V rms 14 V pk) into 600 Ohms inorder to produce maximum peak SPL over the operating bandwidth of the loudspeaker

AC Voltage : 264 Volts

Audio Input Type : Differential electronically balanced

Wiring : Pin 1: Chassis/earth through 220 k Ohms 1000 pF 15 V clamp network to provide virtual ground lift at audiofrequencies Pin 2: Signal + Pin 3: Signal - Case: Earth ground and chassis

CMRR : >50 dB typically 80 dB (50 Hz - 500 Hz)

Signal to Noise : >110 dB

Phase Response : 1 Hz - 16 kHz Â±45 Degree

DC Voltage : 6000 Volts

Overall Length : Female XLR input with male XLR loop outputor VEAM all-in-one connector (integrates AC audio and network)

AC Power Connector : 250 V AC NEMA L6-20 (twistlock) inlet or IEC 309 male inlet or VEAM

Maximum SPL (Sound Pressure Level) : 138 dB

Vertical Coverage : Varies depending on array length and configuration

Maximum Common Mode Range : Â±15 V DC clamped to earth for voltage transient protection

DC Blocking : None on input DC blocked through signal processing

RF Filter : Common mode: 425 kHz Differential mode: 142 kHz

TIM Filter : Integral to signal processing (<80 kHz)

Amplifier Type : Complementary Power MOSFET output stages (class AB/H)

THD IM TIM : <.02 %

Automatic Voltage Selection : Automatic two ranges each with high-low voltage tap (uninterrupted)

Nominal Input Sensitivity : 0 dBV (1 V rms 1.4 V pk) continuous is typically the onset of limiting for noise and music

Transducer - Low/Mid Frequency (front) : Two 18 Inch cone drivers with neodymium magnets Nominal impedance: 4 Ohms Voice coil size: 4 Inch Power-handling capability: 1200 W (AES)

Transducer - Low/Mid Frequency (rear) : Two 15 Inch cone drivers Nominal impedance: 8 Ohms Voice coil size: 3 Inch Power-handling capability: 720 W (AES)

Product Weight : 68.04 kg

Maximum load protection : 4 Ohms front channels 8 Ohms rear channels

Active Power : 3020 Watt

Coverage Horizontal : 100 degrees

Color : Black

Construction : Powder-coated hex stamped steel

Minimum Frequency Response (Bandwidth) : 60 Hz

Maximum Frequency Response (Bandwidth) : 18 kHz

Current Draw : 28.30 Amps

Impedance (High Frequency) : 8 ohm

Impedance (Mid Frequency) : 4 ohm

Impedance (Low Frequency) : 4 ohm

Power Handling (High Frequency) : 720 Watt

Power Handling (Mid Frequency) : 1800 Watt

Power Handling (Low Frequency) : 1800 Watt

Aanbod van verhuurders