Meyer Sound 700-HP

Depth : 762 mm

Dynamic Range : >110 dB

Enclosure : Multi-ply hardwood

Finish : Black textured

Height : 571.50 mm

Width : 1166.62 mm

Phase Response : 45 Hz - 145 Hz Â±30 degree

Free Field Frequency Response : 30 Hz - 125 Hz Â±4 dB Measured with 1/3 octave frequency resolution at 4 meters

Coverage : 360 degree (single unit); varies with number of units and configuration

Inrush Current : 7 A pk (115 V AC); 7 A pk (230 V AC); 10 A pk (100 V AC)

Maximum Peak SPL : 139 dB Measured with music at 1 meter

Operating Frequency Range : 28 - 150 Hz Recommended maximum operating frequency range. Response depends upon loading conditions and room acoustics

Amplifier Type : Two-channel complementary power MOSFET output stages (class AB/H)

Automatic Voltage Selection : Automatic two ranges each with high-low voltage tap

Safety Agency Rated Operating Range : 95 V AC â?? 125 V AC 208 V AC - 235 V AC; 50/60 Hz

Turn-on and Turn-off Points : 85 V AC - 134 V AC; 165 V AC - 264 V AC; 50/60 Hz

Ultimate Short-Term Peak Current Draw : 39 A pk (115 V AC); 20 A pk (230 V AC); 45 A pk (100 V AC)

Transducers - Low Frequency : Two 18 inch cone drivers

Audio Input - Type : Differential electronically balanced

Audio Input - Connector : Female XLR input with male XLR loop output or VEAM all-in-one (integrates AC audio and network)

Audio Input - Maximum Common Mode Range : Â±15 V DC clamped to earth for voltage transient protection

Audio Input - Input Impedance : 10 k ohms differential between pins 2 and 3

Audio Input - DC Blocking : None on input DC blocked through signal processing

Audio Input - CMRR : >50 dB

Audio Input - TIM Filter : Integral to signal processing (<80 kHz)

Audio Input - Nominal Input Sensitivity : 0 dBV (1 V rms 1.4 V pk) continuous is typically the onset of limiting for noise and music

AC Power - Connector : 250 V AC NEMA L6-20 (twist lock) IEC 309 male inlet or VEAM

Current Draw: Idle Current : 0.640 A rms (115 V AC); 0.320 A rms (230 V AC); 0.850 A rms (100 V AC)

Max Long-Term Continuous Current : 8.8 A rms (115 V AC); 4 A rms (230 V AC); 10 A rms (100 V AC) (>10 sec)

Burst Current : 19 A rms (115 V AC); 9.5 A rms (230 V AC); 22 A rms (100 V AC) (<1 sec)

Protective Grill : Perforated metal grille lined with acoustical black mesh

Amplifier - THD IM TIM : < .02 %

Amplifier - Output Power : 2250 W (1125 W/channel) Amplifier wattage rating is based on the maximum unclipped burst sine-wave rms voltage the amplifier will produce into the nominal load impedance. Both channels 67 V rms (95 V pk) into 4 ohms

Transducers - Nominal Impedance : 4 ohms

Transducers - Voice coil size : 4 in

Transducers - Power-handling capability : 1200 W (AES) Power handling is measured under AES standard conditions: transducer driven continuously for two hours with a band-limited noise signal having a 6 dB peakto-average ratio

Audio Input - RF Filter Common mode : 425 kHz

Audio Input - RF Filter Differential mode : 142 kHz

Audio Input - Input Level : Audio source must be capable of producing a minimum of +20 dBV (10 V rms 14 V pk) into 600 Ohms inorder to produce maximum peak SPL over the operating bandwidth of the loudspeaker

Amplifier - Load Capacity : 4 ohms each channel

Amplifier - Cooling : Forced air cooling two fans (one ultrahigh-speed reserve fan)

Width w/rigging : 1285 mm

Height w/rigging : 572 mm

Depth w/rigging : 762 mm

Weight w/rigging : 117.48 kg

Aanbod van verhuurders