ETC SmartModule 6×2,3kW

GENERAL

• four 6a or six 10a dimmers

• Underwriters Laboratories cUL Marked, tested and listed to

  the following standards:

- UL508 (File: E152039)

• Complies with eSta DmX512-a Standards

• Installation requires attachment of safety cables, main power

  and data via DmX

  MECHANICAL

• manufactured of aircraft quality anodized aluminum with a black anodized nish

• Integrated suspension points (threaded studs) for mounting hardware such as C-clamps

• Eyehook for safety cable attachment on larger module

  ELECTRICAL

• 120V 60Hz Mains supply

• 4 x 6a unit:

  • -  120V Single-phase 2-wire + ground, 20A feed

  • -  Power wiring by use of an attached exible 12’ So feed

    cord and bare-ends (connector not supplied)

  • -  fuse per dimmer for load protection

  • -  edison and Stage Pin outlets only

• 6 x 10a unit:

  • -  120/208 Three-phase 4-wire + ground, 20A feed.

  • -  Power feed via a ange-mount Twist-Lok inlet (HBL2515) or

    a cable feed

  • -  Circuit breaker per dimmer for load protection

  • -  Edison, Stage Pin or Twist-Lok outlets

    Note: Not designed for use with ourescent ballasts

    THERMAL

    • Maximum operating temperature up to 78°C (172°F) • Humidity between 30 - 95% non-condensing
     

• Convection cooled – operates without cooling fans or lters.

• optimum cooling when mounted horizontally with the

  control panel vertical (or upright)

  CONTROL FEATURES

  • DmX512 In and thru via 5Pin Xlr connectors
  • Supports up to 32 SmartModules on one DMX line
  • High contrast 2-line by 20-character backlit LCD with graphic

  channel level indication
  • 9-button keypad plus arrow array and Enter button
  • 2 status leD indicators: Power and Valid DmX
  • Soft patch any dimmer to any DmX channel
  • Programmable options per dimmer: max/ min levels, response

  time, non-dim operation, dimmer curve (flourescent curve not

  available at 120V operation)
  • local manual control and 20 preset chase patterns for stand

  alone operation
  • Programmable start modes with soft start for higher wattage

  lamps and burst start for cold laments
  • DMX Backup settings – Selectable Data loss Behavior
  • Password protection for access to DMX, Con guration and

  Install menus