Apogee SA-600B

Product afbeelding: Apogee SA-600B
Bekijk de aanbieders
Beschrijving
  • Output Power (stereo)
    • 8Ω 500W
    • 4Ω 480W
    • 2Ω 600W
  • Output Power (bridged)
    • 8Ω 1200W
    • 4Ω 1200W
  • FREQUENCY RESPONSE: 20 Hz to 20 kHz, +0, -0.3dB, At All Power Levels
  • THD: < 0.07% (4 ohms, 1kHz, 400W)
  • SMPTE INTERMODULATION DISTORTION (IMD): < 0.01%, 60 Hz & 7 kHz, Rated Power @ 8Ω
  • SLEW RATE: 35V/microsecond, Input Filter Bypassed
  • DAMPING FACTOR: 400:1, 1 kHz @ 8Ω
  • INPUT COMMON MODE REJECTION (CMR): Greater than 90dB
  • VOLTAGE GAIN: 40 X (32dB)
  • INPUT SENSITIVITY: For Rated Power @ 4Ω. SA-600B: 1.2V
  • INPUT IMPEDANCE: 13k ohms, Balanced
  • HUM and NOISE: Better than -117dBA
  • CROSSTALK: Better than -80dBA
  • CONNECTORS: Input - XLR Balanced, Output - 5-way Binding Posts
  • COOLING: Front-to-Rear Tunnel, Dual Variable Speed DC Fans
  • CONTROLS: DA Series: Two front panel detented shaft encoder LEVEL controls, channel LINK switch, level control LOCK switch, DISPLAY toggle switch, STEREO / BRIDGE switch, GROUND LIFT switch. SA Series II and CA Series: Two detented LEVEL controls, STEREO / BRIDGE switch, GROUND LIFT switch.
  • CHANNEL INDICATORS: DA Series: Large backlit Liquid Crystal Display for each channel showing: Channel On/Off (Mute State), Phase State, Output Voltage, Output Wattage, Load Impedance, AC Mains Voltage, Temperature, and Attenuation Levels (in 0.5db increments). Each channel also has a Clip LED, Limit LED, Signal LED, Fault LED and Ready LED.
  • SA Series II and CA Series: Each channel has a Clip LED, Limit LED, Signal LED, Fault LED and Ready LED.
  • MASTER INDICATORS: LEDs indicating Power On/Off status, Network Control status (DA only) and Breaker Trip warning.
  • PROTECTION: Electronic Circuit Breaker (may be remotely reset), High Temperature, DC, turn-on delay with power ramp-up, ultrasonic, short circuit.
  • LINE VOLTAGE: 100/120/220-240 VAC internally user configurable, electronic circuit breaker
  • CONSTRUCTION: 16 gauge welded steel chassis, 10 gauge continuous front-to-rear side rails with front and rear rack ears.
  • DIMENSIONS: 19” (483mm) wide by 3.5” (89mm) high (2 EIU rack spaces) by 18.5” (470mm) deep.
  • WEIGHT: 60 LBS. (27.2 KG)
Breid je netwerk uit
Blijf marktconform

Voor dit product zijn nog geen aanbiedingen aanwezig.