Apogee DA-800
Beschrijving
- FREQUENCY RESPONSE: 20 Hz to 20 kHz, +0, -0.3dB, at all power levels
- THD: < 0.007% (4 ohms, 1 kHz, 400W)
- SMPTE INTERMODULATION DISTORTION (IMD): < 0.01%, 60 Hz & 7 kHz, rated power @ 8 ohms
- SLEW RATE: 35V/microsecond, input filter bypassed
- DAMPING FACTOR: 400:1, 1 kHz @ 8 ohms
- INPUT COMMON MODE REJECTION (CMR): Greater than 90 dB
- VOLTAGE GAIN: 40x 32 dB
- INPUT SENSITIVITY: For rated power @ 4 ohms; 1.53V,
- INPUT IMPEDANCE: 13k ohms, balanced
- HUM and NOISE: Better than -117 dBA
- CROSSTALK: Better than -80 dBA
- CONNECTORS: Input - XLR balanced, output - 5-way binding posts
- COOLING: Front-to-rear tunnel, dual variable speed DC fans
- CONTROLS: DA-Series: two front panel detented shaft encoder Level controls, channel Link switch, level control Lock switch, Display toggle switch, Stereo/Bridge switch, Ground Lift switch
- CHANNEL INDICATORS: DA-Series: Large backlit liquid crystal display for each channel showing: Channel On/Off (Mute State), Phase State, Output Voltage, Output Wattage, Load Impedance, AC Mains Voltage, Temperature, and Attenuation Levels (in 0.5dB increments); each channel also has a Clip LED, Limit LED, Signal LED, Fault LED and Ready LED
- MASTER INDICATORS: LEDs indicating power on/off status, network control status and breaker trip warning
- PROTECTION: Electronic circuit breaker (may be remotely reset), high temperature, DC, turn-on delay with power ramp-up, ultrasonic, short circuit
- LINE VOLTAGE: 100/120/220-240 VAC internally user configurable, electronic circuit breaker
- CONSTRUCTION: 16-gauge welded steel chassis, 10-gauge continuous front-to-rear side rails with front and rear rack ears
- DIMENSIONS: 19" (483mm) W x 3.5" (89mm) H (2 EIU rack spaces) x 18.5" (470mm) D
- WEIGHT: 60 lbs. (27.2 kg)
Breid je netwerk uit
Blijf marktconform
Voor dit product zijn nog geen aanbiedingen aanwezig.